Image may be NSFW. Clik here to view. |
Nope. No sealant. Dry as a bone. |
Off and on, I'd been wondering what was going on inside the tires during the past nine months, so when I went out to the bike barn and found the rear completely flat, it was a opportunity to take a peek.
First I tested to see if there was an obvious, egregious leak by pumping it up. The tire held air fine, though it lost much of its pressure in a few minutes. So, I popped one of the beads open and discovered that the Stan's sealant had disappeared.
I suppose it's more accurate to say that the pool of sealant inside the tire was no longer present, but lots of goo was adhering the bead to the rim. A puddle of sealant, or tire blood as Stella likes to call it, is essential to tubeless tire health by coagulating into small leaks, so its absence was the likely reason for the flat.
While I was at it, I was wondering how the Gorilla Tape was holding up, so I pulled the tire off to inspect. After carefully going over the whole surface, things looked good. The single layer of tape was still strongly adhered. Along the way, I cleaned as much goo off the rim as seemed practicable, paying special attention to the bead seating surfaces, so reseating the tire would go smoothly.
I also cleaned the tire beads, ending up with a pile of Stan's sealant boogers.
After I remounted the tire, I hit it with a shot of compressed air. Both beads popped confidently into place and the pressure held well. Bingo. So I cracked open one of the beads and added two ounces of fresh Stan's to the inside. Shake. Spin. Ready to roll for another several months. I'll just have to remember to have some valve stems with removable cores on hand next time.
In all, remarkably quick and easy, especially considering the epic struggle with the same brand of tire and rim that I experienced not long ago. In the end, it's been well worth the time investment, and gets easier each time.
Now, for no particular reason, some recent photos from my yard.